Spray Injection Nozzle Selection Table

The table below summarizes much of the information in the spray injection nozzle section of the BETE Limited website. It is intended to be handy reference guide to aid nozzle selection. Full data on each of the nozzles listed can be accessed by clicking on the boxes in the left hand column of the table below. The data sheets will open in a separate tab to allow easy comparisons between multiple product sheets.

Nozzle Type

Design Type

Minimum flow rate

Profile

Injection uses

PJ series Low profile misting nozzle

Impingement

0.034

Medium

Gas only for low flow rate

Microwhirl misting nozzle

Small orifice misting nozzle

0.032

Lowest

Gas or liquid low flow rate.

Low flow rate spiral nozzle

Spiral

0.534

Long

Gas only

Medium to high flow rates

Clog resistant

Tangential whirl full cone

0.8

Low

Gas or liquid

Medium to high flow rates

Clog resistant

Spray Injection Engineering Considerations

Spray Injection Nozzle Designs