Mist pattern nozzle selection table

The table below summarises much of the information in the mist spray pattern nozzle section of the BETE Limited web site. It is intended to be handy reference guide to aid nozzle selection. Full data on each of the nozzles listed can be accessed by clicking on the boxes in the left hand column of the table below. The PDF's will open in a separate browser tab to allow easy comparison of products.

Nozzle Type

Design Type

Properties

Available spray angle

Flow rate range

Operating pressure range

Microwhirl misting nozzle

Small orifice

Mist at low pressure fog at high pressure

Drip free

70

0.032-0.517

7 - 300

MHW multi headed misting nozzle

Small orifice

Multiple nozzles on single head

90

4.2-8.7

70 - 80

Ultimist axial whirl misting nozzle

Axial whirl

Hollow cone mist

High number of droplets below 60 microns

Available in plastic

Mesh strainer

1.5-61.1

3 - 80

PJ series low profile misting nozzle

Impingement

Produces high percentage of droplets under 50 microns

Finest for of any direct pressure nozzle

90

0.031-5.34

2 - 70

P series misting nozzle

Impingement

Produces high percentage of drops in the 25-400 micron range ideal for dust suppression

90

0.153-30.3

1 - 30

 
Low flow rate spiral nozzle

 Spiral Clog resistant
Low pressure
Relatively course mist especially at low pressures 
 90  0.53 - 25  0.5* - 20 
* At very low pressures the L series will not produce a mist pattern.

Misting Nozzle Designs

mist nozzle selection table